Whirlpool RF367LXSQ Installation Instructions - Page 10

Level Range 1. Place rack in oven. Place level on rack and check levelness of range, first side to side; then front to back. Moving the Range WARNING If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. On Ranges Equipped with Storage Drawers: Use ³⁄₈" drive ratchet and channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. On Ranges Equipped with Warming Drawers: Use channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. NOTE: Oven must be level for satisfactory baking conditions. 2. Replace the storage drawer (and warming drawer on some models). Complete Installation 1. Be sure to check all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Be sure to check you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Be sure to check that the range is level. See "Level Range." 5. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by protective shipping material. Dry thoroughly with a soft cloth. For more information, read the "Range Care" section of the Use and Care Guide. 6. Read "Range Use" in the range Use and Care Guide. 7. Plug into a grounded outlet. Turn power on. 8. Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: s Household fuse is intact and tight; or circuit breaker has not tripped. s Range is plugged into a grounded outlet. s Electrical supply is connected. s See "Troubleshooting" in the Use and Care Guide. 9. When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and contact a qualified technician. Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering. If removing the range is necessary for cleaning or maintenance: 1. Unplug range or disconnect power. 2. Slide range forward to complete cleaning or maintenance. 3. Make sure anti-tip bracket is installed: s Look for the anti-tip bracket securely attached to floor. s Slide range back so rear foot is under anti-tip bracket. 4. Check that range is level. 5. Plug in range or reconnect power. 10