Whirlpool UVL6036JSS Owners Manual - Page 10

Install Hood Liner Internal Blower Motor, Single Blower Motor Assembly, AA BB

Get Whirlpool UVL6036JSS PDF manuals and user guides View all Whirlpool UVL6036JSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Install Hood Liner Internal Blower Motor 1. Install the hood liner blower motor assembly inside the hood liner canopy with the wiring connection to the left for the single motor system and to the front or top for the dual motor system. Single Blower Motor Assembly 3. Run the power supply wires and connector from the range hood through the hole in the right end of the motor mounting plate. A A A. Wiring connection Dual Blower Motor Assembly A B A. Motor mounting plate hole B. Power supply wires and connector 4. Push the right end of the motor mounting plate up and snap it into the spring tab. NOTE: The spring tab should be outside the slot in the mounting plate. A A. Wiring connection 2. Slide the left mounting plate flange under the motor mounting bracket. B A. Motor mounting plate B. Spring clip 5. Align mounting holes in motor mounting plate with motor mounting clip nuts and install 6 x 16 mm screws and 6.4 mm lock washers (quantity two for single motor; quantity five for dual motor). AB A. Motor mounting bracket B. Mounting plate left flange 10 C B A A. Screw with lock washer B. Mounting hole in motor mounting plate C. Clip nut (6 mm)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
10
Install Hood Liner Internal Blower Motor
1.
Install the hood liner blower motor assembly inside the
hood liner canopy with the wiring connection to the left for
the single motor system and to the front or top for the dual
motor system.
Single Blower Motor Assembly
Dual Blower Motor Assembly
2.
Slide the left mounting plate flange under the motor
mounting bracket.
3.
Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
4.
Push the right end of the motor mounting plate up and snap
it into the spring tab.
NOTE
: The spring tab should be outside the slot in the
mounting plate.
5.
Align mounting holes in motor mounting plate with motor
mounting clip nuts and install 6 x 16 mm screws and 6.4 mm
lock washers (quantity two for single motor; quantity five for
dual motor).
A
A. Wiring connection
A
A. Wiring connection
B
A
A. Motor mounting bracket
B. Mounting plate left flange
A
B
A. Motor mounting plate hole
B. Power supply wires and connector
A
B
A. Motor mounting plate
B. Spring clip
A
B
C
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut (6 mm)