Whirlpool UXB1200DYS Installation Guide - Page 3

INSTALLATION REQUIREMENTS INSTALLATION INSTRUCTIONS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Phillips screwdriver Parts supplied (600 CFM models) Remove parts from packages. Check that all parts are included. ■ Blower assembly ■ Motor support bracket ■ Motor spring clip ■ 2 - 6 x 1 mm nuts ■ 5 - 4.2 x 8 mm screws ■ 2 - 6 x 16 mm screws ■ 2 - 6.4 x 11 mm lock washers ■ T-20 Torx®† adapter Parts supplied (1200 CFM models) Remove parts from packages. Check that all parts are included. ■ Blower assembly ■ Motor support bracket ■ Motor spring clip ■ 5 - 6 x 1 mm nuts ■ 5 - 4.2 x 8 mm screws ■ 5 - 6 x 16 mm screws ■ 5 - 6.4 x 11 mm lock washers ■ T-20 Torx®† adapter Prepare Internal Blower System IMPORTANT: Perform steps 1-4 before mounting the range hood. 1. Remove grease filters from range hood. See the "Range Hood Care" section in the Use and Care Guide. 2. Install the motor support bracket using three 4.2 x 8 mm screws. Screw bracket to the inside top or back (alternate location on some models), toward the left side of the range hood. 3. Install motor spring clip using two 4.2 x 8 mm screws. Screw spring clip to the inside top or back (alternate location on some models) of the range hood at the proper location for the selected motor system. Slide the mounting tab of the spring clip through the slot in the panel and secure with the screws. Use the inside set of mounting holes for the single motor system. Use the outside set of mounting holes for the dual motor system. B A DE C A. 4.2 x 8 mm screws (3) for motor support bracket B. 4.2 x 8 mm screws (2) for motor spring clip C. Motor support bracket D. Motor spring clip (single motor assembly location) E. Motor spring clip (dual motor assembly location) †®TORX is a registered trademark of Saturn Fasteners, Inc. 3