Whirlpool UXG7480VDS Dimension Guide - Page 1

Wall-Mount Canopy Grill Vent Hood M PRODUCT MODEL NUMBERS UXG7360V UXG7480V Electrical: 120-volt, 60-Hz, AC-only, 15-amp fused electrical circuit is required. LOCATION REQUIREMENTS Canopy grill vent hood location should be away from strong draft areas, such as windows, doors and strong heating vents. Venting methods This canopy grill vent hood is factory set for venting through the roof or through the wall. A 10" (25.4 cm) round vent system is needed for installation (not included). The hood exhaust opening is 10" (25.4 cm) round. NOTE: Flexible vent is not recommended. Flexible vent creates back pressure and air turbulence that greatly reduce performance. Vent system can terminate either through the roof or through the wall. To vent through a wall, a 90° elbow is needed. Rear discharge A 90° elbow may be installed immediately above the hood. Roof Venting C Wall Venting B B C A A D D A. Optional decorative duct cover B. 10" (25.4 cm) round vent C. Roof cap D. 10" (25.4 cm) round vent transition A. Optional decorative duct cover B. 10" (25.4 cm) round vent and elbow C. Wall cap D. 10" (25.4 cm) round vent transition Calculating Vent System Length To calculate the length of the system you need, add the equivalent feet (meters) for each vent piece used in the system. Vent Piece 10" (25.4 cm) Round 45° elbow 2.5 ft (0.8 m) 90° elbow 5.0 ft (1.5 m) Maximum equivalent vent length is 35 ft (10.7 m). PRODUCT DIMENSIONS Vented installations 12" (30.5 cm) 4" (10.2 cm) 30" (76.2 cm) 36" (91.4 cm) 48" (121.9 cm) INSTALLATION DIMENSIONS 18" (45.7 cm) 24" (61.0 cm) AX M Example vent system 90 elbow 6 ft (1.8 m) *NOTE: The grill vent hood duct cover is designed to add 12" (30.5 cm) to meet the ceiling or soffit height. Depending on your model, order: Part Number W10153151 for 30" (76.2 cm) models, Part Number W10153152 for 36" (91.4 cm) models, Part Number W10153153 for 48" (121.9 cm). IMPORTANT: Minimum distance "X": 30" (76.2 cm) Suggested maximum distance "X": 36" (91.4 cm) Wall cap 2 ft (0.6 m) The following example falls within the maximum recommended vent length of 35 ft (10.7 m). 1 - 90° elbow 1 - wall cap 8 ft (2.4 m) straight = 5.0 ft (1.5 m) = 0.0 ft (0.0 m) = 8.0 ft (2.4 m) Length of system = 13.0 ft (3.9 m) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. W10153187 02-20-09