Whirlpool UXT3030AYW Installation Guide - Page 9

2. Lift the range hood up under cabinet and determine final location by centering beneath cabinet. Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood. Set range hood aside on a covered surface. A NOTE: The 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vent connector can be installed up to 1" (2.5 cm) on either side of the hood center to accommodate off center ductwork. B A C A. Keyhole slot 3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown. D A A. Drill pilot hole 4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads and cabinet to slide range hood into place. ¹⁄₄" (6.4 mm) 5. For roof installations, remove the top rectangular vent knockout. For wall installations, remove the rear rectangular vent knockout. A B B A. Vertical connector B. 3.5 x 9.5 mm screws C. Vent knockouts D. Horizontal connector ■ If a vent damper is installed with a wall cap with damper, check that they do not interfere with each other. Remove the vent connector damper flap if they interfere. Power Supply Cable Installation 1. For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the hood electrical terminal box. For optional power supply cord kit installations, follow the instructions in the "Make Electrical Connections" section. NOTE: Do not reconnect power until the installation is complete. 2. Remove the screw from the terminal box cover. Remove terminal box cover and set aside. A. Top rectangular vent knockout B. Rear rectangular vent knockout A 6. Install the 3¼" x 10" (8.3 x 25.4 cm) vent connector. Attach to B range hood with the 3.5 x 9.5 mm screws provided and remove tape from damper flap. A. Terminal box cover B. Screw 9