Whirlpool UXT5230AYS Installation Guide - Page 13

To Replace the Filter, Replacing the Halogen Lamp

Get Whirlpool UXT5230AYS PDF manuals and user guides View all Whirlpool UXT5230AYS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

To Replace the Filter: 1. To reinstall the filter, the single slot opening on the long edge of the filter is to be toward the front of the range hood. Place the back edge of the filter into the channel at the rear of the range hood. 2. Pull the filter retainer toward the front of the range hood and push the front of the filter up into place. 3. Release the filter retainer. It will spring back into place to secure the filter. 4. Replace the screw into the filter retainer. Replacing the Halogen Lamp Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp. If new lamps do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Push up on the lens and turn it counterclockwise. 3. Remove the lamp and replace it with a 120-volt, 50-watt maximum halogen lamp with a GU10 base. Turn it clockwise to lock it into place. 4. Repeat steps 2-3 for the other lamps if needed. 5. Reconnect power. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
13
To Replace the Filter:
1.
To reinstall the filter, the single slot opening on the long edge
of the filter is to be toward the front of the range hood. Place
the back edge of the filter into the channel at the rear of the
range hood.
2.
Pull the filter retainer toward the front of the range hood and
push the front of the filter up into place.
3.
Release the filter retainer. It will spring back into place to
secure the filter.
4.
Replace the screw into the filter retainer.
Replacing the Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare fingers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1.
Disconnect power.
2.
Push up on the lens and turn it counterclockwise.
3.
Remove the lamp and replace it with a 120-volt, 50-watt
maximum halogen lamp with a GU10 base. Turn it clockwise
to lock it into place.
4.
Repeat steps 2-3 for the other lamps if needed.
5.
Reconnect power.