Whirlpool UXT5536AAS Use & Care Guide - Page 11
Range Hood Care - water filter
View all Whirlpool UXT5536AAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Range Hood Controls A B C D E A. On/Off light button B. Blower Off button C. Blower speed minimum button D. Blower speed medium button E. Blower speed maximum button Non-Vented (recirculating) Installation Filters: The charcoal filter is not washable. It should last up to six months with normal use. Replace with Charcoal Filter Kit Number W10272068. To replace charcoal filter: 1. Cover the grill that protects the blower motor with the charcoal filter so that the slots on the filter correspond to the pins on the sides of the motor protection grill. Operating the light The On/Off light button controls both lights. Press once for On and again for Off. Operating the blower The Blower Speed buttons turn the blower on and control the blower speed and sound level for quiet operation. The speed can be changed anytime during fan operation by pressing the desired blower speed button. The Blower Off button turns the blower Off. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water, or all-purpose cleanser ■ Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Metal Grease Filter: 1. Remove each filter by pulling the spring release handle and then pulling down the filter. AB C A. Charcoal filter B. Pins C. Blower motor 2. Turn the charcoal filter clockwise to lock it. 3. Repeat steps 1-2 on the other filter. Replacing a Halogen Lamp Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. Replace bulb, using tissue or wearing cotton gloves to handle bulb. If new lamps do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Push up on the lens and turn it counterclockwise. A A. Spring release handle 2. Wash metal filters as needed in dishwasher or hot detergent solution. 3. Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track. 4. Push in spring release handle. 5. Push up on metal filter and release handle to latch into place. 6. Repeat steps 1-5 for the other filter. 3. Remove the bulb and replace it with a 120-volt, 50-watt maximum halogen bulb with a GU10 base. Turn it clockwise to lock it into place. 4. Repeat steps 2-3 for the other bulb if needed. 5. Reconnect power. 11