Whirlpool W3CG3014XS Installation Instructions - Page 9

Typical flexible connection 1. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see G in the following illustration). 2. Attach 1 adapter and nipple to the gas pressure regulator and the other adapter and nipple to the gas shutoff valve. Tighten both adapters and nipples. 3. Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked. B A C D H A. ³⁄₈" nipple B. ³⁄₈" adapter C. Flexible connector D. ½" nipple F G E E. Gas pressure regulator F. ½" adapter G. Use pipe-joint compound. H. Manual gas shutoff valve Complete Connection 1. Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A B A. Closed valve B. Open valve 2. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found. 3. Remove surface burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Place burner grates over burners and caps. B A C WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 4. Plug into a grounded 3 prong outlet. Attach Cooktop to Countertop NOTE: This section applies only if you are using clamping brackets. G A B F E D C A. Glass cooktop B. Cooktop base C. Attachment screw D. Clamping bracket (extends far enough beyond cooktop base to allow installation of clamping screws) E. 2½" (6.4 cm) clamping screw F. Countertop G. Foam seal 1. Place the 2½" (6.4 cm) clamping screws into the outermost hole in the clamping bracket. 2. Check that the cooktop is still level. 3. Use a screwdriver to tighten the screws against the countertop. Do not overtighten. A. Igniter electrode B. Burner cap C. Burner base 9