Whirlpool WDF518SAHM Installation Instructions - Page 9

INSTALLATION INSTRUCTIONS WARNING 4. Sand holes smooth Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. Failure to do so can result in death or electrical shock. Wood Cabinet Metal Cabinet 1. Disconnect power Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. 2. Shut off water supply Shut off the water supply to the dishwasher. PREPARE CABINET OPENING- NEW UTILITIES 3. Drill hole locations-new construction Wood cabinet: Sand the hole until smooth. Metal cabinet: Cover edges of hole with grommet included with power cord kit. See the "Tools and Parts" section part details. Helpful Tip: Wiring the dishwasher will be easier if you route the cable into the cabinet opening from the right-hand side. MOISTURE BARRIER - RECOMMENDED FOR WOOD COUNTERTOPS 5. Moisture barrier/wood shims Moisture barrier Optional location 11/2" (38 mm) Preferred location 1/2" (12.7 mm) Make sure the area under the cabinet is clean and dry for installation of the moisture barrier. Remove the backing of the moisture barrier, and apply to underside of the countertop along the front edge of the counter. NOTE: Refer to the "Product and Cabinet Opening Dimensions" section for the correct hole placement and dimensions of the shaded area. Drill a 11/2" (38 mm) drain hose hole in the side or rear of cabinet, depending on location of drain hose routing and drain hose connection location. Drill a 1/2" (12.7 mm) water supply hose hole in the side or rear of cabinet, depending on location of water supply routing and connection location Drill a 11/2" (38 mm) electrical conduit hole in the right-hand side or rear of cabinet. 9