Whirlpool WDF730PAYM Installation Guide - Page 17
Adjust Door Spring Tension - Stainless Steel Tub Models, Adjust Door Spring Tension - Plastic Tub
View all Whirlpool WDF730PAYM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted. NOTE: Depending upon the type of tub you have, the door spring tension is adjusted differently. Refer to the section that applies to your tub type. Adjust Door Spring Tension - Stainless Steel Tub Models When door is unlatched and door opens by itself, move the tensioner to a higher numbered hole and replace the screw. Reattach door spring to rear frame. NOTE: Tensioners on both sides of dishwasher should be secured at same holes. Proceed to Step 6. Adjust Door Spring Tension - Plastic Tub Models To adjust the door spring tension, unhook the spring from the rear frame of dishwasher. Using a nut driver or hex socket, remove the screw from the tensioner. The screw can be put into one of three holes (1, 2, 3) in the front leg of dishwasher. If the door closes by itself, move the tensioner to a lower number hole and replace the screw. Reattach door spring to rear frame. NOTE: Tensioners on both sides of dishwasher should be secured at same holes. If the door closes too quickly, decrease the spring tension by moving the spring end toward the front of the dishwasher. NOTE: Springs should be in the same notches on left and right sides. 17