Whirlpool WDT730PAHV Installation Guide - Page 12
Dishwasher Height Adjustment Chart
View all Whirlpool WDT730PAHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
11. Measure cabinet opening NOTE: If the minimum cabinet opening height is less than 337/8" (860 mm), the rear leveling legs and spacers can be removed for additional clearance. This will allow the dishwasher to fit into a 331/2" (851 mm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Rear and front leveling legs are preset at the factory for 341/2" [876 mm].) 12. Adjust leveing legs Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed. Be sure to measure the lowest point on the underside of the countertop and the highest point on the floor. Dishwasher Height Adjustment Chart Cabinet opening height Front legs height A Rear legs height B 331/2" (851 mm) 3/8" (9.8 mm) Remove legs and spacers. 34" (864 mm) 7/8" (22 mm) 1" (25.4 mm) 341/2" (876 mm) 11/8" (28.8 mm) 11/4" (31.3 mm) Front legs - A Refer to the "Dishwasher Height Adjustment Chart" for height of leveling legs needed for your cabinet opening. 13. Remove plastic rail cover (only on certain models) Plastic rail cover Rear legs - B Remove and discard the plastic rail cover on each side of the dishwasher frame. To remove the plastic rail cover, push upward and back to unsnap it from the dishwasher frame. B Adjust both front and back leveling legs to the same height. 12