Whirlpool WDT750SAHV Installation Guide - Page 14
POWER CORD CONNECTION, Hose clamp final position, Remove terminal box, Remove cover, Install strain
View all Whirlpool WDT750SAHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
21. Hose clamp final position Drain hose Drain hose stop Small clamp Rubber drain hose connector Stop Stop NOTE: Route drain hose out the rear of the dishwasher. POWER CORD CONNECTION NOTE: If removing a previous dishwasher with a power cord, you will need to transfer the power cord to the new dishwasher. 22. Remove terminal box 24. Install strain relief Install a UL Listed/CSA Approved metallic strain relief. Make sure screw heads are facing up when tightening conduit nut. Strain relief is provided with the power cord kit. See the "Tools and Parts" section at the front of the guide for part details and orders. 25. Power cord - route cord into terminal box Use a 1/4" nut driver or 1/4" hex head socket wrench to remove the screw that holds the terminal box to the cross brace. Then, tilt the terminal box, free the tab, and lift the terminal box away from the crossbar. 23. Remove cover Route cord so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cord through strain relief in terminal box. NOTE: A maximum of 2 power cord supply conductors (12 AWG largest size) plus 1 grounding conductor are permitted in the terminal box. Remove the cover by sliding it up and lifting its hooks out of the slot. Retain cover for later use. 14