Whirlpool WDT970SAHV Installation Guide - Page 20
Direct Wire Connection
View all Whirlpool WDT970SAHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
48. Check door clearance DIRECT WIRE CONNECTION 51. Remove terminal box IMPORTANT: Check that top of door does not contact screws, brackets, or countertop. If it does, adjust leveling legs or use the side attachment option. 49. Check inner spacing Use a 1/4" nut driver or 1/4" hex head socket wrench to remove the screw that holds the terminal box to the cross brace. Then, tilt the terminal box, free the tab, and lift the terminal box away from the crossbar. 52. Remove cover Open door and check that space between dishwasher cabinet opening and tub is equal on both sides. If spacing is not equal, loosen bracket screws and shift tub. Tighten bracket screws. 50. Reinstall plastic buttons Plastic button Remove the cover by sliding it up and lifting its hooks out of the slots. Retain cover for later use. 53. Unclip green, white, and black wires If side attachment method was used, reinstall the gray plastic buttons removed in Step 39 to hide the screw holes. There should be adequate length in the wires to pull the terminal box out from under the dishwasher. Lift the wires off of the nearby clips or components to extend the length of wire harness for easier access. 20