Whirlpool WED4800BQ Installation Guide - Page 17

If you do not feel heat, turn off dryer, and check the following: ■■ There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician. NOTE: You may notice an odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away. Reverse Door Swing (Optional) 29" Super Wide Side-Swing Door 1. Place towel on dryer 3. Lift door off top screws Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from dryer cabinet. 4. Remove screws from hinges Place towel on top of dryer to avoid damaging the surface. NOTE: Magnetized screw driver is helpful. 2. Remove bottom screws Remove screws attaching hinges to door. 5. Remove screws from door Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer cabinet side of hinges. Remove screws at top, bottom, and side of door (4 screws) that hold the inner and outer door together. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. Set outer door aside. NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches. 17