Whirlpool WED4850BW Installation Guide - Page 8
Power Supply Cord Connection - dryer
View all Whirlpool WED4850BW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Direct Wire 2. Remove terminal block cover Power Supply Cord Connection Power supply cord strain relief 1. Attach power supply cord strain relief A B C D Remove the screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the tabs of the two clamp sections (C) into the hole (B) below the terminal block opening so that one tab is pointing up (A) and the other is pointing down (D), and hold in place. Tighten strain relief screws just enough to hold the two clamp sections (C) together. 2. Attach power supply cord to strain relief BC D A E F Before you start, disconnect power. Remove hold-down screw (D) and terminal block cover (A). A. Terminal block cover B. External ground conductor screw C. Center terminal block screw D. Hold-down screw E. Neutral ground wire F. Hole below terminal block cover Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. For 3-wire Power Supply Cord Connection, see page 9. For 4 wire Power Supply Cord Connection, continue to step 3. 8