Whirlpool WED5010LW Owners Manual - Page 20
Connect Vent (Vented Models Only), Level Dryer, Connect vent to exhaust outlet
View all Whirlpool WED5010LW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Connect Vent (Vented Models Only) 1. Connect vent to exhaust outlet Check levelness of dryer from side to side. Repeat from front to back. NOTE: The dryer must be level for the moisture-sensing system to operate correctly. Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp. 2. Move dryer to final location 2. Adjust leveling legs Move dryer to final location. Avoid crushing or kinking the vent. After dryer is in place, remove corner posts and cardboard from under dryer. Level Dryer 1. Level Dryer If dryer is not level, prop up using a wood block. Use wrench to adjust legs up or down, and check again for levelness. Once dryer is level, make sure all four legs are snug against the floor and the dryer does not rock. 3. Install and remove base trim (on some models) To Install: Place the skirt to bottom of dryer and match the locating pins with the holes. Press the skirt firmly upwards until it snaps into place. To Remove: On each corner, push down on top of base trim. Rotate away from dryer and remove. 20