Whirlpool WED5100HW Owners Manual 1 - Page 14
ground wire and neutral wire
View all Whirlpool WED5100HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3. Connect neutral wire C B 2. Connect neutral ground wire and neutral wire E C B Place hooked end of neutral wire (white or center) (C) of direct wire cable under center terminal block screw (B). Squeeze hooked end together. Tighten screw. 4. Connect remaining wires Connect neutral ground wire (E) and neutral wire (white or center wire) (C) of power supply cord or cable under center terminal block screw (B). Tighten screw. 3. Connect remaining wires Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Connect remaining wires to outer terminal block screws Tighten screws. 4. Connect external ground wire Optional 3-wire Connection You must verify with a qualified electrician that this grounding method is acceptable before connecting. 1. Prepare to connect neutral ground wire and neutral wire G A Connect a separate copper ground wire (G) from the external E B ground conductor screw (A) to an adequate ground. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." A Remove center terminal block screw (B). Remove neutral ground wire (E) from external ground conductor screw (A). 14