Whirlpool WED5800BW Use & Care Guide - Page 12

TROUBLESHOOTING CONT. First try the solutions suggested here or visit our website at www.whirlpool.com/product_help In Canada www.whirlpool.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Dryer displaying code message Cycle time too short "PF" (power failure), Start LED flashes "F# E#" (F1 E1, F3 E1, etc.) variable service codes. Sensor cycle ending early. Was the drying cycle interrupted by a power failure? Press START/PAUSE to restart the dryer. If a code beginning with an "F" appears in the display. Alternating between F# and E#, the dryer control has detected a problem that requires service. Call for service. The load may not be contacting the sensor strips. Level the dryer. Use Timed Dry for very small loads. Change the dryness level setting on Sensor Cycles. Increasing or decreasing the dryness level will change the amount of drying time in a cycle. If loads are consistently ending too early, see also "Changing the Sensor Cycle Settings." Lint on load Lint screen clogged. Lint screen should be cleaned before each load. Stains on load or drum Dryer fabric softener not properly used. Loads are wrinkled Load not removed from dryer at the end of the cycle. Dryer is tightly packed. Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can stain your garments. Drum stains are caused by dyes in clothing (usually blue jeans). These will not transfer to other clothing. Select Touch Up Cycle to tumble the load with water and heat. This cycle is best for smoothing out wrinkles and reducing odors from loads consisting of wrinkle-free cotton, cotton polyester blends, common knits, and synthetic garments. NOTE: Refer to garment care label instructions. Dry clean only garments are not recommended. Dry loosely packed loads that can tumble freely. Odors Load is too hot You have recently been painting, staining, or varnishing in the area where your dryer is located. The electric dryer is being used for the first time. Laundry items removed from the dryer before the end of the cycle. A high temperature cycle was used, or a separate temperature control was set on high. If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing. The new electric heating element may have an odor. The odor will be gone after the first cycle. Allow the Cool Down cycle to finish before removing laundry from dryer. All cycles are cooled slowly to reduced wrinkling and make it easier to handle. Items removed before Cool Down may feel very warm. Select a lower temperature, and use a sensor drying cycle. These cycles sense the temperature or the moisture level in the load and shut off when the load reaches the selected dryness. This reduces overdrying. 12