Whirlpool WED6600V Use and Care Guide - Page 25

3. Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the drying rack. 4. Close the door. 5. Press the POWER button. 6. Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only temperature setting. 7. You must select a time by pressing TIME ADJUST Up or Down. Reset time as needed to complete drying. Refer to the following table. 8. Press (and hold) START button (about 1 second). This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold. Rack Dry Setting Temp. Time* Wool Sweaters Timed Low 60 Block to shape and lay flat on Dry the drying rack. Stuffed toys or pillows Timed Low 60 Cotton or polyester fiber filled Dry Stuffed toys or pillows Foam rubber filled Timed Dry Air Only 90 (no heat) Sneakers or canvas shoes Timed Dry Air Only 90 (no heat) *(Minutes) Reset time to complete drying, if needed. DRYER CARE Cleaning the Dryer Location Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. WARNING Every load cleaning 1. The lint screen is located on the top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. Cleaning the Lint Screen Clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT: ■ Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics. ■ If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. 2. Push the lint screen firmly back into place. As needed cleaning 1. Roll lint off screen with your fingers. 2. Wet both sides of lint screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Insert lint screen back into dryer. 25