Whirlpool WED70HEBW Use & Care Guide - Page 7

1 POWER Touch to turn the dryer on and off. Touch to stop/cancel a cycle at any time. 2 CYCLE CONTROL KNOB Use your dryer's cycle control knob to select available cycles on your dryer. Turn the knob to select a cycle for your laundry load. See "Cycle Guide" for detailed descriptions of cycles. 3 START/PAUSE Touch and hold until the LED comes on to start a cycle, or touch once while a cycle is in process to pause it. 4 LED DISPLAY AND SETTINGS When you select a cycle, its default settings will light up and the Estimated Time Remaining (for Automatic Cycles) or actual time remaining (for Manual Cycles) will be displayed. For times longer than 99 minutes, hours will be displayed followed by minutes. Automatic Cycles are Heavy Duty, Normal, Bulky, Casual (on some models), Delicates, and Sanitize (on some models). Manual Cycles are Quick Dry and Timed Dry. The Steam Cycle (on some models) is Steam Refresh. Touch along the bottom of the display to adjust settings. Touch "+" or "-" with Manual Cycles to increase or decrease the length of a Timed Dry or Quick Dry cycle. See "Cycle Guide" for available settings on each cycle. Not all settings are available with all cycles. Cycle Status Lights The indicator bar at the top of the display will let you know what stage of the drying cycle is in process. For more information on each stage, see "Cycle Status Indicators." Temp When using Manual Cycles, you may select a dry temperature based on the type of load you are drying. Use the warmest setting safe for the garments in the load. Follow garment label instructions. NOTE: Automatic Cycles use a preset temperature that is not adjustable. Dryness Level You may adjust the Dryness Level on Automatic Cycles (except for the Sanitize cycle), if desired. NOTE: Dryness Level is for use with Automatic Cycles only. Damp Dry Signal (on some models) Touch to select the Damp Dry Signal. When selected, a series of beeps will sound when the load is damp, but not completely dry. This will allow you to take clothes out of the load that do not need to dry completely. This option is available on Heavy Duty, Normal, Bulky, Casual, and Delicates cycles. The Damp Dry Signal is selected as a default for the Bulky cycle, as a reminder to manually reposition bulky loads midway through the cycle. Wrinkle Shield™ Option If you will be unable to remove a load immediately, touch Wrinkle Shield to add up to 140 minutes of periodic tumbling to help reduce wrinkling. You may select the "With Steam" setting (on some models) to add a short steam cycle after 60 minutes to help smooth out wrinkles. 5 OPTIONS Use to select available options for your dryer. Not all cycles and options are available on all models. A Drum Light (on some models) Touch to turn the LED drum light on or off. The light will also turn on when the door is open, and turn off automatically after about 5 minutes. B Cycle Signal (on some models) Use this to turn the signal indicating the end of a drying cycle on or off. NOTE: You may also turn off the tones that sound when a feature, setting, or option is touched. Touch and hold Cycle Signal for about one second to turn sounds on or off. C Control Lock Use to lock the controls of the dryer and avoid an accidental change in cycle options or preferences during a drying cycle. NOTE: The Control Lock function may be enabled when recovering from a power failure. To unlock the control, touch and hold CONTROL LOCK for at least 3 seconds. 7