Whirlpool WED7500GC Installation Instructions - Page 20

COMPLETE INSTALLATION CHECKLIST q Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. q Check that you have all of your tools. q Dispose of/recycle all packaging materials. q Check dryer's final location. Be sure vent is not crushed or kinked. q Check that dryer is level. See "Level Dryer." q Remove film on console and any tape remaining on dryer. q Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. q Read "Dryer Use" in your "Use and Care Guide." Electric Models: q For power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on Power. Gas Models: q Check that gas supply is on. q Check for leaks. All Models: q Select a Timed Dry heated cycle, and start dryer. Do not select Air Only Temperature setting. If dryer will not start, check the following: • Controls are set in a running or "ON" position. • Start button has been pushed firmly. • Dryer is plugged into an outlet and/or electrical supply is connected. • Household fuse is intact and tight, or circuit breaker has not tripped. • Dryer door is closed. This dryer automatically runs an installation diagnostic routine at the start of its first cycle. If you receive an L2 code, there may be a problem with your home power supply keeping the dryer's heater from turning on. See "Troubleshooting." If your Airflow screen reads "Check Vent", your dryer vent may be crushed or blocked. See "Troubleshooting." NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away. 20