Whirlpool WED75HEFW Installation Guide - Page 25
Move the door strike, Remove inner door from outer door, Remove hinge and latch, from inner door,
View all Whirlpool WED75HEFW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Reverse door swing square-shaped door 1. Remove door from dryer 3. Remove inner door from outer door Release tab Release tab Using a T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Retain or set aside the 4 screws. 2. Move the door strike Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside. NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. 4. Remove hinge and latch from inner door Hinge Using a T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Remove the 4 screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame as shown. Latch Using a T25® screwdriver, remove the 3 screws securing the latch plate and the 5 screws holding the hinge assembly in place. 25