Whirlpool WED8000DW Installation Guide - Page 22

REVERSE DOOR SWING Tools needed: Flat-blade screwdriver Plastic putty knife 4. Remove the 2 plastic plugs (A) located outside the dryer door opening. A A Min. 8" long TORX T25® † screwdriver #2 Phillips screwdriver You can change your door swing from a right-side opening to a left-side opening, if desired. 1. Place a towel or soft cloth on top of dryer or work space to avoid damaging the surface. Remove door from dryer cabinet 1. Open the dryer door. 2. Using a T25® screwdriver, remove screws (A) and then (B) screws from each of the two hinges that attach dryer door to front panel of dryer. Set the hinge screws off to the side for reinstalling the door. A A 5. Install 2 plastic plugs (A) into screw holes where the hinges were removed in Step 4. Reverse the strike 1. Remove the door strike (A) from the dryer door opening. 2. R emove the cosmetic screw (B) opposite the door strike (A). A B AB A B 3. R emove the dryer door by lifting upward and out to lift the door off the cabinet. Lay the door on a flat, covered surface, with the inside of the door facing up. A. Door strike B. Cosmetic screw 3. Reinstall the door strike and cosmetic screw on the opposite side of dryer door opening from where they were removed. N OTE: Door strike and plugs must be on the same side of the dryer door opening. † ® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC. 22