Whirlpool WED8120HW Owners Manual - Page 13
Connect ground wire
View all Whirlpool WED8120HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2. Prepare to connect neutral ground wire and neutral wire 5. Connect remaining wires E B A Remove center terminal block screw (B). Remove neutral ground wire (E) from external ground conductor screw (A). 3. Connect neutral ground wire and neutral wire Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with holddown screw. Now, go to "Venting Requirements." 3-wire Direct Wire Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. E 1. Prepare your 3-wire cable for C B direct connection (251"mm) Connect neutral ground wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of direct wire cable under center screw of terminal block (B). Squeeze hooked ends together and tighten screw. 4. Connect ground wire F (893m½m" ) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 31/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape wire ends into hooks. 2. Remove center screw B A Connect ground wire (green or bare) (F) of direct wire cable to external ground conductor screw (A). Tighten screw. Remove center terminal block screw (B). 13