Whirlpool WED9150WW Installation Instructions - Page 10

4. Connect remaining wires 2. Connect neutral wire B C Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements". 3-wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-wire receptacle (NEMA type 14-30R) 3-prong plug Spade terminals with upturned ends Ring terminals 1. Remove center screw Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements". Direct Wire B Remove center terminal block screw (B). 10