Whirlpool WED9250WW Installation Instructions - Page 4
Location Requirements - dimensions
UPC - 883049188195
View all Whirlpool WED9250WW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
LOCATION REQUIREMENTS DRYER DIMENSIONS Front view: 27" (686 mm) 38" (965 mm) You will need: ■■ A location allowing for proper exhaust installation. See "Venting Requirements." ■■ A separate 30 amp circuit. ■■ If using power supply cord, a grounded electrical outlet located within 2 ft. (610 mm) of either side of dryer. See "Electrical Requirements." ■■ Floor must support dryer weight of 200 lbs. (90.7 kg). Also consider weight of companion appliance. ■■ Cold water faucets located within 4 ft. (1.2 m) of the water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa). You may use the water supply for your washer using the "Y" connector and short hose (if needed) which are provided. ■■ 20-100 psi (138-690 kPa) for best performance. ■■ Level floor with maximum slope of 1" (25 mm) under entire dryer. If slope is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. If not level, clothes may not tumble properly and automatic sensor cycles may not operate correctly. For each arrangement, consider allowing more space for ease of installation and servicing; spacing for companion appliances and clearances for walls, doors, and floor moldings. Space must be large enough to allow door to fully open. Add spacing on all sides of dryer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required. 1" (25 mm) * Approx. measurement Side view: 361/4" (921 mm) 29" (736 mm) 271/4" (695 mm) Left or right side exhaust 41/4" (108 mm) 1" (25 mm) 101/4" (260 mm) 4