Whirlpool WED92HEFU Dimension Guide - Page 1

Dryer Dimensions Front view: 383/4" Min. (984 mm) 39" Max. (990 mm) Side view: Electric Dryer 27" (686 mm) PRODUCT MODEL NUMBERS WED7505F, WED75HEF, WED7740F, WED77HEF, WED8540F, WED85HEF, WED90HEF, WED92HEF Installation spacing for recessed area or closet installation All dimensions show recommended and minimum spacing allowed. ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, floor moldings, and dryer venting. ■■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer. ■■ For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. ■■ Companion appliance spacing should also be considered. Recommended installation clearances (dryer only): 18" min. (457 mm) 3" (76 mm) 48 in.2 min. (310 cm2) Back view: NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See "Venting Requirements." Power supply cord/cable Vent Water inlet (Steam models only) 61/2" (165 mm) 297/8"* (759 mm) 31/2"* (89 mm) 0" - 5"* (0" - 127 mm) 0"-5"* (0 mm-127 mm) 24 in.2 min. (155 cm2) 3" (76 mm) 1"* (25 mm) 1" (25 mm) *0" (0 mm) spacing is allowed for straight-back venting only. For steam models only, inlet hose must not be kinked. Minimum installation clearances (dryer only): Front Sides Rear Top Recessed NA 0" (0 mm) 0" (0 mm)** 0" (0 mm) Closet NA 0" (0 mm) 0" (0 mm)** 0" (0 mm) Under Counter NA 1" (25 mm) 0" (0 mm)** 0" (0 mm) **0" (0 mm) spacing is allowed for straight-back venting only. Custom under counter installation: 3/4"* (18 mm) *Approx. measurement. 143/8" (365 mm) 61/8"* (156 mm) W10868947A 10/2016