Whirlpool WEG515S0F Installation Instructions - Page 12

Remove/Replace Drawer, Oven Door, Complete Installation

Page 12 highlights

Remove/Replace Drawer Remove all items from inside the storage drawer, and then allow the range to cool completely before attempting to remove the drawer. To Remove: 1. Open the drawer to its fully open position. 2. Raise the front edge and then lift out. To Replace: 1. Align the forward drawer notches with the notches in the drawer rails on both sides. Place the rear alignment tabs into the drawer rails on both sides. 2. Push the drawer in all the way. 3. Gently open and close the drawer to ensure it is seated properly on the rails on both sides. Oven Door For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is OFF and cool. Then, follow these instructions. The oven door is heavy. To Remove: 1. Open oven door all the way. 2. Pinch the hinge latch between two fingers and pull forward. Repeat on other side of oven door. A A. Hinge latch 3. Close the oven door as far as it will shut. 4. Lift the oven door while holding both sides. Continue to push the oven door closed and pull it away from the oven doorframe. To Replace: 1. Insert both hanger arms into the door. Be sure that the hinge notches are engaged in the oven doorframe. A A. Hinge notch 2. Open the oven door. The door should be able to open all the way. 3. Move the hinge levers back to the "locked" position. Check that the door is free to open and close and is level while closed. If it is not, repeat the removal and installation procedures. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Check that you have all of the range accessories, especially oven racks. These accessories may be in the range packaging. 4. Dispose of/recycle all packaging materials. 5. Check that the range is level. See the "Level Range" section. 6. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the "Range Care" section of the User Guide. 7. Read the User Guide. 8. Turn on surface burners and oven. See the User Guide for specific instructions on range operation. NOTE: Odors and smoke are normal when the oven is used the first few times. If Range Does Not Operate, Check the Following: ■■ Household fuse is intact and tight, or circuit breaker has not tripped. ■■ Gas pressure regulator shut-off valve is in the "open" position. ■■ Range is plugged into a grounded 3 prong outlet. ■■ Electrical supply is connected. 9. When the range has been ON for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shut-off valve is open. ■■ If the gas supply line shut-off valve is closed, open it, and then repeat the 5-minute test as outlined above. ■■ If the gas supply line shut-off valve is open, close it, and contact a qualified technician. If You Need Assistance or Service: Please reference the "Warranty" section of the User Guide to contact service. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

12
Remove/Replace Drawer
Remove all items from inside the storage drawer, and then
allow the range to cool completely before attempting to
remove the drawer.
To Remove:
1.
Open the drawer to its fully open position.
2.
Raise the front edge and then lift out.
To Replace:
1.
Align the forward drawer notches with the notches in the
drawer rails on both sides. Place the rear alignment tabs into
the drawer rails on both sides.
2.
Push the drawer in all the way.
3.
Gently open and close the drawer to ensure it is seated
properly on the rails on both sides.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is OFF
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Open oven door all the way.
2.
Pinch the hinge latch between two fingers and pull forward.
Repeat on other side of oven door.
3.
Close the oven door as far as it will shut.
4.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away
from the oven doorframe.
A
A. Hinge latch
To Replace:
1.
Insert both hanger arms into the door. Be sure that the
hinge notches are engaged in the oven doorframe.
2.
Open the oven door.
The door should be able to open all the way.
3.
Move the hinge levers back to the “locked” position.
Check that the door is free to open and close and is level
while closed. If it is not, repeat the removal and installation
procedures.
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Check that you have all of the range accessories, especially
oven racks. These accessories may be in the range
packaging.
4.
Dispose of/recycle all packaging materials.
5.
Check that the range is level. See the “Level Range” section.
6.
Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see
the “Range Care” section of the User Guide.
7.
Read the User Guide.
8.
Turn on surface burners and oven. See the User Guide
for specific instructions on range operation.
NOTE:
Odors and smoke are normal when the oven is used
the first few times.
If Range Does Not Operate, Check the Following:
Household fuse is intact and tight, or circuit breaker has
not tripped.
Gas pressure regulator shut-off valve is in the “open” position.
Range is plugged into a grounded 3 prong outlet.
Electrical supply is connected.
9.
When the range has been ON for 5 minutes, check for heat.
If the range is cold, turn off the range and check that the gas
supply line shut-off valve is open.
If the gas supply line shut-off valve is closed, open it,
and then repeat the 5-minute test as outlined above.
If the gas supply line shut-off valve is open, close it,
and contact a qualified technician.
If You Need Assistance or Service:
Please reference the “Warranty” section of the User Guide
to contact service.
A
A. Hinge notch