Whirlpool WET4124H Installation Instructions - Page 12
Electrical Requirements, 240V Electric Models - Canada, 120V Electric Models - U.S.A., and Canada 24
![]() |
View all Whirlpool WET4124H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Electrical Requirements, 240V Electric Models - Canada Electrical Requirements, 120V Electric Models - U.S.A. and Canada (24" [61 cm] Models Only) n It is recommended that a separate circuit breaker serving only this appliance be provided. n 120V models are equipped with a power supply cord having a 3 prong grounding plug intended to be plugged into a 20 amp 5-20R wall receptacle. n To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance 5-20R receptacle with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. n If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. n Check with a qualified electrician if you are not sure the washer/dryer is properly grounded. n Do not have a fuse in the neutral or ground circuit. n 120 volt, 60 Hz, AC only, 20 amp fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is your responsibility: n To contact a qualified electrical installer. n To be sure that the electrical connection is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70 - latest edition or the Canadian Electrical Code, C22.1 - latest edition and all local codes and ordinances. A copy of the above code standards can be obtained from: National Fire Protection Association, One Batterymarch Park, Quincy, MA 02269 or Canadian Standards Association, 178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA. n Do not use an extension cord. 12 It is your responsibility: ■■To contact a qualified electrical installer. ■■To be sure that the electrical connection is adequate and in conformance with Canadian Electrical Code, C22.1 - latest edition and all local codes. A copy of above codes standard may be obtained from: Canadian Standards Association, 178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA. ■■To supply the required 4-wire, single-phase, 120/240 volt, 60 Hz, AC only electrical supply on a separate 30 amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit. ■■This dryer is equipped with a UL Listed and/or CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle. The cord is 5 ft. (1.52 m) long. Be sure wall receptacle is within reach of dryer's final location. 4-wire receptacle (14-30R) If using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement Part Number 9831317. For further information, please reference service numbers located in "Assistance or Service" section of your Use and Care Guide.
![](/manual_guide/products/whirlpool-wet4124hw-installation-instructions-56767fb/12.png)