Whirlpool WET4124HW Installation Instructions - Page 30
Make Gas Connection, Gas 27 [69 cm] Models Only
View all Whirlpool WET4124HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
6. Check for leaks Make Gas Connection (Gas 27" [69 cm] Models Only) 1. Preparing to connect gas supply to dryer A. Flared male fitting B. Non-flared male fitting B A Turn on water faucets to check for leaks. A small amount of water may enter washer. It will drain later. 7. Secure drain hose Laundry Tub Standpipe Wall Remove red cap from flexible gas connector. Remove the 1/2" NPT adapter from the flexible gas connector (it will be necessary to use two adjustable wrenches). Use pipe-joint compound on threads of all non-flared male fittings. If flexible metal tubing is used, be sure there are no kinks. NOTE: For propane gas connections, you must use pipe-joint compound resistant to action of propane gas. Do not use TEFLON® tape. 2. Install adapter 44..545"."5" (1(11134mmmm) ) 4.5" ((111134 mmmm)) 44..55"" (1143 mm) Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with plastic strap included in the parts package. It is the responsibility of the installer to install and secure the drain hose into the provided plumbing/drain in a manner that will avoid the drain hose coming out of or leaking from the plumbing/drain. A A. 1/2" rigid gas supply pipe B. Use pipe-joint compound. B C.1/2" NPT adapter C D. Do not use pipe-joint D compound. E. Flexible gas E connector Install the adapter on the 1/2" rigid gas supply pipe using pipe-joint compound. NOTE: For propane gas connections, you must use pipe-joint compound resistant to action of propane gas. Do not use TEFLON® tape. 30