Whirlpool WFC7500VW Owners Manual - Page 14

Restarting To restart the washer at any time, select CANCEL/DRAIN. Changing Cycles and Options Not all Options are available with all Cycles. Cycles and Options can be changed anytime before START is selected. To stop a cycle and select a new cycle 1. Press and hold CANCEL/DRAIN for 3 seconds. 2. Select desired cycle. 3. Select the desired OPTIONS. 4. Select and hold START (for approximately 3 seconds) to restart the washer at the beginning of the new cycle. To cancel a cycle and to drain the washer manually 1. Press and hold CANCEL/DRAIN for 3 seconds. 2. The pump will turn on to drain out the water and the door will unlock. NOTE: It will take approximately 1 minute for the door to unlock. 3. The washer cycle stops, the door unlocks and clothes can be removed. 4. To power down the washer manually after the wash cycle is complete, switch knob to Off position. NOTE: If the water level is too high, the washer will drain automatically before the door unlocks. Status Lights These lights show which portion of the cycle the washer is operating. Sensing The washer automatically weighs items then adjusts the Estimated Time Remaining, based on the cycle selected. Cycle Complete The Cycle Complete status light stays on for 1 hour after the cycle is complete. To power down the washer manually after the wash cycle is complete, switch knob to Off position. Estimated Time Remaining The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The oversuds routine removes extra suds and assures proper rinsing of your garments. The options you select will also affect the cycle times that are shown in the Preset Cycle Settings table. The Estimated Time Remaining can change to much longer times under extreme conditions. Door Locked When the Door Locked LED light illuminates, the door is locked. The door is locked and unlocked automatically, depending on the stage of the wash cycle. Press and hold CANCEL/DRAIN for 3 seconds to unlock the door manually. It will take approximately 1 minute for the door to unlock. Cycles Wash Cycles Choose Wash Cycles by rotating the Cycle selector knob to the desired cycle. The indicator light for the cycle selected will illuminate. Each cycle is designed for different types of fabric and soil levels. ■ Each cycle has a default cycle time, WASH TEMP, and may have preset Options. The preset settings provide the recommended fabric care for the selected cycle. ■ The preset settings can be changed anytime before START is selected. Not all Options and Modifiers (WASH TEMP, spin options) are available with all Cycles. Select and hold START (for approximately 3 seconds) to continue the cycle. Preset Cycle Settings Each cycle has a preset Cycle Time and WASH/RINSE TEMP. The preset settings provide the recommended fabric care for the selected cycle. See chart. Cycle Estimated Time* (hr:min) Wash Temp Spin Speed Normal 0:50 Warm High Quick Wash 0:30 (2-3 items) Warm High Delicate 0:37 Warm Low Clean Washer 1:15 Hot High Drain/Spin 0:18 N/A High Rinse/Spin 0:24 Cold High Heavy Duty 1:10 Warm High Casual 0:45 Warm Low *The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. 14