Whirlpool WFE525S0H Installation Instructions - Page 9
wire connection: Power Supply Cord
View all Whirlpool WFE525S0H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Style 2: Direct wire strain relief ■ Remove the knockout as needed for the flexible conduit connection. ■ Assemble a UL listed conduit connector in the opening. A If your home has: 3-wire direct ³⁄₈" (1.0 cm) And you will be Go to Section: connecting to: A circuit breaker 3-wire connection: box or fused Direct wire disconnect 3" (7.6 cm) B A. Removable retaining nut B. Conduit ■ Tighten strain relief screw against the flexible conduit. 4-wire connection: Power Supply Cord Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out and removed. 5. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: And you will be Go to Section: connecting to: 4-wire receptacle (NEMA type 14-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 4-wire connection: Power supply cord 4-wire direct ³⁄₈" (1.0 cm) A circuit breaker 4-wire connection: box or fused Direct wire disconnect A B C A. Metal ground strap B. Discard C. Ground-link screw 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. A B 5" (12.7 cm) 3-wire receptacle (NEMA type 10-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 3-wire connection: Power supply cord C D A. Terminal block B. Ground-link screw C. UL listed strain relief D. Power supply cord wires 9