Whirlpool WFE540H0AH Installation Guide - Page 14
Storage Drawer, Oven Door
View all Whirlpool WFE540H0AH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
To Replace: 1. Align the forward drawer notches with the notches in the drawer glides on both sides. Place the rear alignment tabs into the drawer glides on both sides. 3. Slowly push the drawer into the range. A A B A. Drawer alignment tab B. Drawer glide notch 2. Push the warming drawer or premium storage drawer in all the way. 3. Gently open and close the warming drawer or premium storage drawer to ensure it is seated properly on the glides on both sides. Storage Drawer (on some models) The storage drawer can be removed. Before removing, make sure drawer is cool and empty. To Remove: 1. Pull the storage drawer straight back to the drawer stop. A. Engage drawer glide. NOTE: When properly installed, the rear slides on the bottom of the drawer will engage the base rails and the drawer will not tip when items are placed in the drawer. Oven Door For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy. To Remove: 1. Open oven door all the way. 2. Pinch the hinge latch between two fingers and pull forward. Repeat on other side of oven door. A A. Hinge latch 3. Close the oven door as far as it will shut. 4. Lift the oven door while holding both sides. Continue to push the oven door closed and pull it away from the oven door frame. A A. Drawer stop notch 2. Lift up the front of the drawer and pull the drawer out. To Replace: 1. Lift up the front of the drawer and place the rear of the drawer inside the range so that the drawer stop notch is behind the drawer glide. 2. Lower the drawer so that the edge of the slide rail drops into the slot in the drawer glide. 14 To Replace: 1. Insert both hanger arms into the door. 2. Open the oven door. You should hear a "click" as the door is set into place. 3. Move the hinge levers back to the locked position. Check that the door is free to open and close. If it is not, repeat the removal and installation procedures.