Whirlpool WFG320M0MS Owners Manual - Page 7

ELECTRONIC OVEN CONTROL Display When power is first supplied to the appliance, a flashing time will appear on the display. Press CANCEL to clear flashing time from the display. If flashing time appears, a power failure has occurred. Press CANCEL and reset the clock if needed. When the oven is not in use, the display shows the time of day. When performing a cook or timer function, the display will show either hours and minutes, or minutes and seconds. Oven Indicator Lights The indicator lights are located on both sides of the display. The indicator lights light up or flash when the oven is in one of the following modes: Bake, Broil or Timer. Start START begins any oven function. If START is not pressed within 5 seconds after pressing a function pad, the Push to START ("PSH") indicator light will flash and the push to start tone will sound as a reminder. If START is not pressed within 1 minute after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled. Cancel CANCEL stops any function except the Clock, Timer, and Control Lock. Clock This is a 12 hour clock and does not show a.m. or p.m. To Set: Before setting, make sure the oven and Timer are off. Press CANCEL to cancel the oven, and press Timer Set/Off twice to cancel the timer. 1. Press Clock. 2. Press the Temp/Time "up" or "down" arrow pads to set the time of day. 3. Press Clock or START. Tones Tones are audible signals, indicating the following: One tone ■ Valid pad press ■ Oven is preheated (long tone) ■ Function has been entered Three tones ■ Invalid pad press ■ Push to start reminder Cycling tones ■ End of cycle Fahrenheit and Celsius The temperature is preset at Fahrenheit, but can be changed to Celsius. To Change: Press and hold the Temp/Time up arrow keypad for 5 seconds. "°C" or "°F" will appear on the display. Repeat to change back to Fahrenheit. To exit mode, press CANCEL or wait 3 seconds. Timer The timer can be set in hours or minutes up to 12 hours and 59 minutes, and counts down the set time either in hours and minutes, or in minutes and seconds. The timer does not start or stop the oven. To Set: 1. Press Timer Set/Off. The timer indicator light will light up. 2. Press the Temp/Time "up" or "down" arrow pads to set the length of time. 3. Press START. When the set time ends, end-of-cycle tones will sound. 4. Press Timer Set/Off pad twice anytime to cancel the timer and reminder tones. If CANCEL is pressed, the oven will turn off and the cook function will be disabled. To display the time of day for 5 seconds when the timer is counting down, press Clock. If START is not pressed within 5 seconds after pressing Timer Set/Off or Temp/Time arrow pads, the "PSH" indicator light will flash and the push to start tone will sound as a reminder. If no action is taken after 1 minute, the display will return to the time of day or bake or broil mode. The timer can be reprogrammed to change the time while it is running. To Reprogram: 1. Press Timer Set/Off. 2. Press the Temp/Time "up" or "down" arrow pads to adjust time. 3. Press START. 7