Whirlpool WFG320M0MW Installation Instructions - Page 16

To Convert Oven Burner 1. Open the oven door and remove oven racks and oven tray with flame spreader, and set aside. 2. Remove screw from the oven burner. Lift oven burner and pull the burner toward you. The orifice spud is behind the oven burner air shutter. A B C A. Oven burner B. Air shutter C. Screw 3. Locate Natural gas orifice spud stamped "49" in the bag containing literature supplied with the range. 4. Use a 3/8" (1 cm) combination wrench to remove the Propane gas orifice spud. 5. Install the number "49" Natural gas spud. Complete Conversion 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Turn the manual shut-off valve in the gas supply line to the open position. 3. Refer to the "Electronic Ignition System" section for proper burner ingestion, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LOW" setting for each cooktop burner. Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame 1/4" to 1/2" (6.4 mm to 13 mm) long. The outer cone is not as distinct as the inner cone. Natural gas flames do not have yellow tips. 4. Close the broiler door and turn the knob to OFF position. 5. Refer to the "Complete Installation" section to complete this procedure. A A. Natural gas oven orifice spud stamped with "49" IMPORTANT: Do not overtighten. 6. Place Propane gas oven burner spud in plastic parts bag along with Propane gas cooktop burner spuds for future use and keep with the bag containing literature. 7. Reinstall oven burner. 8. Reinstall oven racks, oven tray, and flame spreader. 16