Whirlpool WFG550S0H Installation Instructions - Page 19
To Convert Surface Burners Propane Gas to Natural, To Convert Oven Bake Burner Propane Gas to,
View all Whirlpool WFG550S0H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
To Convert Surface Burners (Propane Gas to Natural Gas) 1. Remove burner cap. 2. Remove the burner base. A B E D C A. Burner cap B. Burner base C. Alignment pins D. Igniter electrode E. Gas tube opening 3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. AB D C A. Igniter electrode B. Orifice spud C. Orifice spud holder D. Screws 4. Gas orifice spuds are stamped with a number on the side or top. Replace the propane gas orifice spud with the correct Natural gas orifice spud. Refer to the following chart for the correct Natural gas orifice spud placement. Natural Gas Orifice Spud Chart Burner Rating Size (mm) ID Number 18,000 BTU 2.00 200AM 17,000 BTU 1.96 196AM 15,000 BTU 1.80 180AM 9,500 BTU 1.40 140AM 8,000 BTU 1.30 130AM 5,000 BTU 1.00 100AM NOTE: Refer to the model/serial/rating plate located on the oven frame behind the top right-hand side of the oven door for proper sizing of spuds for each burner location. 5. Place propane gas orifice spuds in the orifice spud bag. IMPORTANT: Keep the propane gas orifice spuds in case of reinstallation with propane gas. 6. Replace the burner base. 7. Replace burner cap. 8. Repeat steps 1 to 7 for the remaining burners. To Convert Oven Bake Burner (Propane Gas to Natural Gas) 1. Remove the oven racks. 2. Remove 2 screws at the rear of the oven bottom. 3. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and set it aside on a covered surface. A B XXX XXX A A. Stamped number A. Screws B. Oven bottom 19