Whirlpool WFW560CHW Owners Manual - Page 22

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com/owners (in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) (cont.) "rL" (remove load) appears in display Load detected in drum during Clean Remove items from washer drum and restart Clean Washer Washer with affresh® cycle. with affresh® cycle. F# E# or F## E## code other than as described above appears in display Washer making error beeps Washer beeps when Start/ Pause is touched Clean Washer LED flashing at end of wash cycle (on some models) System error code. Door has not been opened and closed for at least three cycles. Door not closed. The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer with affresh® cycle. Touch POWER once to clear the code. Then touch POWER again to restart washer. If code appears again, call for service. Unplug washer for 30 seconds; then plug back in. This code may occur when the washer is first turned on. Open and close the door to clear the display. Close the door completely. Run the Clean Washer with affresh® cycle. If the Clean Washer with affresh® cycle is not turned on, the LED will stop flashing at the end of a wash cycle after running three more regular wash cycles. After 30 more wash cycles are completed, the Clean Washer with affresh® LED will again flash at the end of a wash cycle as a reminder. 22