Whirlpool WGD5600XW Installation Instructions - Page 16
Place towel on dryer, Remove bottom screws, Lift door off top screws, Remove screws from hinges,
UPC - 883049200156
View all Whirlpool WGD5600XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
29" Super Wide Side-Swing Door 1. Place towel on dryer 4. Remove screws from hinges Place towel on top of dryer to avoid damaging the surface. 2. Remove bottom screws Remove screws attaching hinges to door. 5. Remove screws from door Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer cabinet side of hinges. 3. Lift door off top screws Remove screws at top, bottom, and side of door (4 screws). Keep door screws separate from hinge screws as they are diferent sizes. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches. 6. Rotate outer door Take outer door and rotate in 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. Insert 4 door screws. Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from dryer cabinet. 16