Whirlpool WGD6150PB Owners Manual - Page 17
Complete Installation Checklist, Install and remove base trim on some models
View all Whirlpool WGD6150PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. Install and remove base trim (on some models) To Install: Place the skirt to bottom of dryer and match the locating pins with the holes. Press the skirt firmly upwards until it snaps into place. To Remove: On each corner, push down on top of base trim. Rotate away from dryer and remove. Complete Installation Checklist � Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. � Check that you have all of your tools. � Dispose of/recycle all packaging materials. � Check dryer's final location. Be sure vent is not crushed or kinked. � Check that dryer is level. See "Level Dryer." � Remove film on console and any tape remaining on dryer. � Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. � Refer to the user instructions in your Quick Start Guide. WARNING All Models: � Set the heat cycle for 20 minutes and start dryer. Do not select Air Only temperature setting. If dryer will not start, check the following: � Controls are set in a running or "ON" position. � Start button has been pressed firmly. � Dryer is plugged into an outlet and/or electrical supply is connected. � Household fuse is intact and tight, or circuit breaker has not tripped. � Dryer door is closed. � When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close the door. If you do not feel heat, turn the dryer off and check to see whether gas supply shutoff valve is open. � If the gas supply shutoff valve is closed, open it and then repeat the 5-minute test as outlined above. � If the gas supply line shutoff valve is open, contact a qualified technician. � To change the door swing from a right-side opening to a leftside opening, see online "Dryer Door Reversal Instructions" for details. If your Airflow screen reads "Check Vent," your dryer vent may be crushed or blocked. NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. � Plug into a grounded 3 prong outlet. � Check that gas supply is on. � Check for leaks. � Check that the flexible gas line is not crushed or kinked. Steam Models Only: � Be sure the water faucets are on. � Check for leaks around "Y" connector, faucet, and hoses. � If you live in a hard water area, use of a water softener is recommended to control the buildup of scale through the water system in the dryer. Over time, the buildup of lime scale may clog different parts of the water system, which will reduce product performance. Excessive scale buildup may lead to the need for certain part replacement or repair. 17