Whirlpool WGD70HEBW Installation Guide - Page 16
Move the door strike, Remove inner door from outer door, Remove outer window assembly, from trim
![]() |
View all Whirlpool WGD70HEBW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
2. Move the door strike 4. Remove outer window assembly from trim ring Using a TORX® T25 screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. 3. Remove inner door from outer door Fig. A Fig. B Using a Phillips screwdriver, remove the 2 screws from the outer window retainer and rotate the outer window assembly clockwise until the square notches line up with the 4 tabs on the trim ring indicated with arrows in the figure A above. Then lift out the outer window and retainer up and off the trim ring and set aside (B). Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside. 16
![](/manual_guide/products/whirlpool-wgd88heac-installation-guide-8a147ee/16.png)