Whirlpool WGD75HEFW Installation Guide - Page 15
Complete Installation, Checklist, Door Reversal Optional
View all Whirlpool WGD75HEFW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
COMPLETE INSTALLATION CHECKLIST q Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. q Check that you have all of your tools. q Dispose of/recycle all packaging materials. q Be sure the water faucets are on. q Check for leaks around "Y" connector, faucet, and hoses. q Check dryer's final location. Be sure vent is not crushed or kinked. q Check that dryer is level. See "Level Dryer." q Remove film on console and any tape remaining on dryer. q Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. q Read "Dryer Use" in your Use and Care Guide. q If you live in a hard water area, use of a water softener is recommended to control the buildup of scale through the water system in the dryer. Over time, the buildup of lime scale may clog different parts of the water system, which will reduce product performance. Excessive scale buildup may lead to the need for certain part replacement or repair. Electric Models q Plug into a grounded outlet. Gas Models q Plug into a grounded outlet. q Check that gas supply is on. q Check for leaks. q Check to be sure that the flexible gas line is not crushed or kinked. All Models: q Select a Timed Dry heated cycle, and start dryer. Do not select Air Only Temperature setting. If dryer will not start, check the following: • Start button has been pressed firmly. • Dryer is plugged into an outlet and/or electrical supply is connected. • Household fuse is intact and tight, or circuit breaker has not tripped. • Dryer door is closed. This dryer automatically runs an installation diagnostic routine at the start of its first cycle. NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away. DOOR REVERSAL (OPTIONAL) The following instructions are for models with a round and square-shaped doors. Tools needed: Min. 8" long TORX T25® †† screwdriver #2 Phillips screwdriver Reverse door swing round-shaped door flat glass - single handle 1. Remove door from dryer IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. †† ® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC. 15