Whirlpool WGD7600XW Owners Manual - Page 13
Warnin, Warning
UPC - 883049202341
View all Whirlpool WGD7600XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Dryer Results Clothes are not drying satisfactorily, drying times are too long, or load is too hot ■ Is the lint screen clogged with lint? Lint screen should be cleaned before each load. WARNING Fire Hazard Use a heavy metal vent. Do not use a plastic vent. Do not use a metal foil vent. Failure to follow these instructions can result in death or fire. ■ Is the exhaust vent or outside exhaust hood clogged with lint, restricting air movement? Run the dryer for 5-10 minutes. Hold your hand under the outside exhaust hood to check air movement. If you do not feel air movement, clean exhaust system of lint or replace exhaust vent with heavy metal or flexible metal vent. See the Installation Instructions. ■ Are fabric softener sheets blocking the grille? Use only one fabric softener sheet, and use it only once. ■ Is the exhaust vent the correct length? Check that the exhaust vent is not too long or has too many turns. Long venting will increase drying times. See the Installation Instructions. ■ Is the exhaust vent diameter the correct size? Use 4" (102 mm) diameter vent material. ■ Is the dryer located in a closet? Closet doors must have ventilation openings at the top and bottom of the door. The rear of the dryer requires 5" (127 mm) of airspace, and the sides and front of the dryer require a minimum of 1" (25 mm). See the Installation Instructions. ■ Has the Air Only modifier been selected? Select the right temperature for the types of garments being dried. See "Additional Features." ■ Is the load too large and heavy to dry quickly? Separate the load to tumble freely. ■ Are clothes coming out of the Quick Refresh cycle with damp or wet spots? Under certain environmental or installation conditions you may expereince underdrying. Select the Timed Dry cycle (20 min. default time), which can be customized by choosing temperature by pressing TEMP and/or cycle time by pressing the Time Adjust up or down buttons. Cycle time too short WARNING Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so can result in back or other injury. ■ Is the automatic cycle ending early? The load may not be contacting the sensor strips. Level the dryer. Change the dryness level setting on Automatic Cycles. Increasing or decreasing the dryness level will change the amount of drying time in a cycle. Lint on load ■ Is the lint screen clogged? Clean lint screen. Check for air movement. ■ Is the dryer located in a room with temperature below 45ºF (7ºC)? Proper operation of dryer cycles requires temperatures above 45ºF (7ºC). 13