Whirlpool WGD8500DW Installation Guide - Page 12
Connect remaining wires, Connect neutral wire, Remove center screw
View all Whirlpool WGD8500DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3-wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3-prong plug Spade terminals with upturned ends Ring terminals 1. Remove center screw Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." DIRECT WIRE CONNECTION B Remove center terminal block screw (B). 2. Connect neutral wire C B Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. 12
12
3-wire receptacle (NEMA
type 10-30R)
3-prong plug
Spade terminals with
upturned ends
Ring terminals
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3-wire Power Supply Cord Connection
3.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to “Venting Requirements.”
2.
Connect neutral wire
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw.
B
C
Remove center terminal block screw (B).
B
1.
Remove center screw
DIRECT WIRE CONNECTION