Whirlpool WGD9250WL Dimension Guide - Page 1

DRYER DIMENSIONS Front view: 27" (686 mm) 35 3/8" (899 mm) Gas Dryer PRODUCT MODEL NUMBERS WGD9050X, WGD9150W, WGD9151X, WGD9250W, WGD9270X, WGD9051Y, WGD9151Y, WGD9371Y Side view: 29" (736 mm) Door open view: 481/8" (1238 mm) 471/8" (1197 mm) Left or right side exhaust 31/2" (89 mm) 1" (25 mm) Back view: 61/4" (159 mm) 6 7/8" (174 mm) 1 5/8" (41 mm) Closet Installation (stacked washer and dryer): 6" (152 mm) Electric 281/8" (715 mm) 31/2" (89 mm) 14" (358 mm) NOTE: Most installations require a minimum 5" (102 mm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements". 3" (76 mm) 71" (1803 mm) 48 in.2 (310 cm2) 51/2" (140 mm) 1" (25 mm) 3" (76 mm) 24 in.2 (155 cm2) 1" (25 mm) Cabinet installation (dryer only): 7" (178 mm) Custom under counter installation (dryer only): 39" min. (990 mm) 18" (460 mm) 1" (25 mm) 1" (25 mm) NOTE: Some models not recommended for undercounter installation. 4" (102 mm) 1" (25 mm) 1" (25 mm) Closet installation (dryer only): 34" recommended (864 mm) 18" min. (457 mm) 3" (76 mm) 48 in.2 (310 cm2) 4" (102 mm) 3" (76 mm) 24 in.2 (155 cm2) 1" (25 mm) 1" (25 mm) Spacing for recessed area or closet installation All dimensions show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides and rear. ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, and floor moldings. ■■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer. ■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilitation openings are acceptable. ■■ Companion appliance spacing should also be considered. ■■ No other fuel-burning appliance may be installed in the same closet as the dryer. W10443045B 02/2012