Whirlpool WGD9500T Use and Care Manual - Page 5

INSTALLATIONINSTRUCTIONS Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. 8" or 10" pipe wrench 8" or 10" adjustable wrench (for gas connections) Flat-blade screwdriver Adjustable wrench that opens to 1" (2.5 cm) or hex-head socket wrench (for adjusting dryer feet) v4" nut driver or socket wrench • Level • Knife • Vent clamps • Pipe-joint compound resistant to LP gas Caulking gun and compound (for installing new exhaust vent) • Pliers • Tape measure Parts supplied Remove parts package from dryer drum. Check that all parts are included. Pedestal Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of different heights separately for this dryer. You may select a 10" (25.4 cm) or 15.5" (39.4 cm) pedestal. These pedestals will add to the total height of the dryer for a total height of approximately 48" (121.9 cm) or 53.5" (135.9 cm), respectively. For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least 9" (22.9 cm) above the floor and the 15.5" (39.4 cm) pedestal at least 3.5" (8.9 cm) above the floor. A B C D A. Leveling legs (4) B. "Y" connector C. Short inlet hose D. Inlet hose with right-angle E. Rubber washer connector NOTE: Do not use leveling legs supplied with dryer if installing on a pedestal. Parts needed Check local codes and with gas supplier. Check existing gas supply, electrical supply and venting. Read "Electrical Requirements," "Gas Supply Requirements" and "Venting Requirements" before purchasing parts. • For close-clearance installations between 31.5" (80.01 cm) and 37" (93.98 cm), see "Plan Vent System" section for venting requirements. I-_- 37" ---_1 (93.9a era) Mobile home installations require special parts (listed following) that may be ordered by calling the dealer from whom you purchased your dryer. For further information, please refer to the "Assistance or Service" section of this manual. • Mobile Home Installation Kit. Ask for Part Number 346764. • Metal exhaust system hardware. A B A. 10" (25.4 cm) pedestal B. 15.5" (39.4 cm) pedestal The pedestals are available in several colors. To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section of this manual. Pedestal Height Color Part Number 10" (25.4 cm} White WHP1000SQ 10" (25.4 cm} Biscuit WHP1000ST 10" (25.4 cm} Diamond Dust (Silver) WHP1000SU 10" (25.4 cm} Black WHP1000SB 15.5" (39.4 cm) White WHP1500SQ 15.5" (39.4 cm} Biscuit WHP1500ST 15.5" (39.4 cm} Diamond Dust (Silver) WHP1500SU 15.5" (39.4 cm} Black WHP1500SB Stack Kit Are you planning to stack your DUET ® washer and dryer? To do so, you will need to purchase a Stack Kit. To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section of this manual. Ask for Part Number 8541503.