Whirlpool WML75011HN Installation Instructions - Page 2
Installation Requirements
View all Whirlpool WML75011HN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
INSTALLATION REQUIREMENTS Tools and Parts Tools needed Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. ■■ Measuring tape ■■ Pencil ■■ Masking tape or thumbtacks ■■ Scissors ■■ No. 3 Phillips screwdriver for ¼- 20 x 3" bolts ■■ Drill ■■ Diagonal wire cutting pliers ■■ Stud finder ■■ 7/16" socket wrench (or box wrench) for 1/4" x 2" lag screws ■■ 1½" (3.8 cm) diam. hole drill bit for wood or metal cabinet ■■ 3/16" (5 mm), 3/8" (10 mm), 5/8" (16 mm) drill bits ■■ 3/4" (19 mm) hole saw ■■ Keyhole saw ■■ Caulking gun and weatherproof caulking compound Parts supplied ■■ Duct tape For information on reordering, see the "Replacement Parts" section. NOTE: The hardware items listed here are for wood studs. For other types of wall structures, be sure to use appropriate fasteners. A B C D E FG H J Materials Needed Standard fittings for wall or roof venting. See the "Venting Design Specifications" section. Location Requirements IMPORTANT: Check the opening where the microwave oven will be installed. The location must provide: ■■ Minimum installation dimensions. See the "Installation Dimensions" illustration. ■■ Minimum one 2" x 4" (50.8 x 101.6 mm) wood wall stud and minimum 3/8" (10 mm) thickness drywall or plaster/lath within cabinet opening. ■■ Support for weight of 150 lbs (68 kg) which includes microwave oven and items placed inside the microwave oven and upper cabinet. ■■ Grounded electrical outlet inside upper cabinet. See the "Electrical Requirements" section. NOTES: ■■ If installing the microwave oven near a left sidewall, make sure there is at least 6" (15.2 cm) of clearance between the wall and the microwave oven so that the door can open fully. ■■ Some cabinet and building materials are not designed to withstand the heat produced by the microwave oven for cooking. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate, or sustain other damages. Special Requirements For Wall Venting Installation Only: ■■ Cutout must be free of any obstructions so that the vent fits properly and the damper blade opens freely and fully. For Roof Venting Installation Only: ■■ If you are using a rectangular-to-round transition piece, the 3" (7.6 cm) clearance needs to exist above the microwave oven so that the damper blade can open freely and fully. See "Rectangular to Round Transition" illustration in the "Venting Design Specifications" section. A. 3/16-24 x 3" round-head bolts (2) Not Shown: B. 1/4-20 x 3" flat-head bolts (2) C. Washers (2) ■ Upper cabinet template D.3/16" toggle nuts (2) E. 1/4" x 2" lag screws (2) F. Sheet metal screws (2) ■ Mounting plate (Located on the upper polyfoam) G. Power supply cord bushing (1) ■ Grease filters H. Damper assembly (for wall or roof venting) ■ Charcoal filters J. Vent cover (2) NOTE: Depending on model, grease filter and charcoal filter may be combined. 2