Whirlpool WMT50011KS Installation Instructions - Page 2

INSTALLATION REQUIREMENTS Tools and Parts Tools Needed Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. ■ Measuring tape ■ Pencil ■ Phillips screwdriver ■ 7/64" drill bit ■ Drill Screw Pack Supplied (not shown to scale) SCREW SCREW ART QTY #7-18x7/16" round-head sheet metal 14 screw Parts supplied for model: WMT55511K and KMBT5511K PART Trim kit frame (standard) PART ART QTY 1 Cooling duct (standard) 2 Rail (standard) 2 #7-16x15/16" flat head wood screw 6 #7-16x7/16" round-head wood screw 10 NOTE: There are some extra screws in the screw pack. They are spares for your use during installation if needed. See below: ■ #7-18x7/16" round-head sheet metal screw: 4 extra. ■ #7-16x15/16" flat head wood screw: 2 extra. ■ #7-16x7/16" round-head wood screw: 4 extra. Parts Supplied (not shown to scale) This installation instruction is for various models. Some parts supplied may have different appearance, depending on your model. NOTE: Trim kit frame (1), Cooling Ducts (2) and Rail (2) parts will need to be purchased to convert from Standard to Slim or from a Slim to a Standard installation. Parts supplied for model: WMT50011K and KMBT5011K PART PART ART QTY Trim kit frame (slim) Parts supplied for all models PART Turntable PART ART Turntable ring Turntable driver QTY 1 1 1 NOTE: The turntable driver is located inside the microwave oven cavity. Remove the tape before use. 1 Cooling duct (slim) 2 Rail (slim) 2 2