Whirlpool WRF560SEYM Use & Care Guide - Page 13
Refrigerator Use - installation
View all Whirlpool WRF560SEYM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
The produce preserver pouches should be installed in the housing, located on the wall of one of the crisper drawers. 1. Remove the FreshFlow™ Produce Preserver pouches from the packaging. 2. Lift up on the housing to remove it from the mounting tab. 3. Open the housing by pulling up and out on the back of the top of the housing. 4. Place both pouches inside the housing, then snap the housing back together. 5. Place the housing back on the mounting tab. Installing the Status Indicator The produce preserver comes with a status indicator, which should be activated and installed at the same time the pouches are installed. REPLACE MONTHS CAUTION IRRITANT Read cautions on back. ATTENTION IRRITANT Lisez des prudences sur le revers. Accessories The following accessories are available for your refrigerator. To order, contact us and ask for the part numbers. In the U.S.A., visit our web page www.whirlpool.com/ accessories or call 1-800-901-2042. In Canada, visit our web page www.whirlpoolparts.ca or call 1-800-807-6777. affresh™† Stainless Steel Cleaner: Order Part #W10355016 affresh™† Stainless Steel Wipes: Order Part #W10355049 affresh™† Kitchen & Appliance Cleaner: Order Part #W10355010 Water Filter: Order Part #W10295370A or FILTER1 Air Filter: Order Part #W10311524 or AIR1 Produce Preserver: Order Part #W10346771A or FRESH1 Water Filter, Air Filter and Ethylene Filter Bundle Pack: Order Part #W10443987BL REFRIGERATOR USE Opening and Closing Doors There are two refrigerator compartment doors. The doors can be opened and closed either separately or together. There is a vertically-hinged seal on the left refrigerator door. ■ When the left side door is opened, the hinged seal automatically folds inward so that it is out of the way. ■ When both doors are closed, the hinged seal automatically forms a seal between the two doors. A 1. Place the indicator face-down on a firm, flat surface. 2. Apply pressure to the bubble on the back of the indicator until the bubble pops, to activate the indicator. 3. Slide open the cap on the top of the produce preserver housing. 4. Place the indicator in the top of the housing, facing outward. 5. Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap. NOTE: The cap will not easily close if the indicator's bubble has not been popped. Replacing the Produce Preserver The disposable pouches should be replaced every 6 months, when the status indicator has completely changed from white to red. To order replacements, contact us. See "Accessories" for information on ordering. 1. Remove the used pouches from the produce preserver housing. 2. Remove the used status indicator. 3. Install the replacement pouches and status indicator using the instructions in the previous sections. A. Hinged seal Using the Controls IMPORTANT: ■ Wait 24 hours for your refrigerator to cool completely before adding food. If you add food before the refrigerator has cooled completely, your food may spoil. NOTE: Adjusting the refrigerator and freezer temperature controls to a colder than recommended setting will not cool the compartments any faster. ■ The recommended setting should be correct for normal household refrigerator use. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm. †™ AFFRESH is a Trademark of Whirlpool, U.S.A. 13