Whirlpool WRS571CIHZ Owners Manual - Page 5

Door Swing Dimensions ■ Location must permit doors to open to a minimum of 165°. ■ In the following graphic, "A" represents the distance needed to fully open the freezer door and "B" represents the distance needed to fully open the refrigerator door. 41¹⁄₄" (104.5 cm) A C D 45⁷⁄₈" (116.4 cm) B C D 90˚ 165˚ ■ Location should permit doors to open fully. See "Product Dimensions." ■ This refrigerator is intended for use in a location where the temperature ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The preferred room temperature range for optimum performance, which reduces electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F (32°C). It is recommended that you do not install the refrigerator near a heat source, such as an oven or radiator. ■ Floor must support refrigerator weight (more than 600 lbs [272 kg]) and contents. Electrical Requirements WARNING Dimension A B C D Flat Doors 13⁵⁄₈" (34.5 cm) maximum* 18¹⁄₈" (46.0 cm) maximum* 2³⁄₄" (6.7 cm) maximum* ¹⁄₈" (0.2 cm) Curved Doors 13³⁄₄" (34.9 cm) 18³⁄₈" (46.4 cm) 3³⁄₄" (9.4 cm) 1¹⁄₄" (2.9 cm) *Dimension may vary based on style of door handle. The width for the largest available handle is listed. Location Requirements WARNING Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can result in death, explosion, or fire. NOTES: ■ The refrigerator can be installed into a recessed opening, at the end of cabinets or as a freestanding refrigerator. ■ If you are installing the refrigerator to fit flush with the front of the base cabinets, all shoe moulding and baseboards must be removed from the rear of the refrigerator opening. Allow for 1" (2.54 cm) of space behind the refrigerator. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. Recommended Grounding Method A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation or cleaning, or removing a light bulb, turn cooling off or turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF, and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and turn cooling on or reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. See "Using the Controls" in the User Instructions, User Guide, or Use & Care Guide. 5