Whirlpool WRS965CIAH Installation Guide - Page 8

5. With the side trims properly seated in the lower trim, slide each trim into the door panel groove. 8. When fully seated, the upper trim should be nearly flush with the top of the freezer door, completely covering both side trim clips. 6. Align the upper trim with the trim clips at the top of each side trim. A 9. Repeat the previous steps to install the refrigerator door panel. Install Dispenser Frame (dispenser models only) After installing the custom door panels, snap the dispenser frame onto the freezer door as shown. A. Trim clip 7. Slide the upper trim into the door panel groove by applying firm downward pressure. Be sure that the grooves on the upper trim are properly aligned with the rivets on the door panel. Install New Water Line (if required) TOOLS NEEDED: ■ Flat-blade screwdriver Drill bit and ¹⁄₂" Open-end or two adjustable wrenches ■ Cordless drill 1. Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water. 2. Find a ¹⁄₂" (12.70 mm) to 1¹⁄₄" (3.18 cm) vertical cold water pipe near the refrigerator. NOTE: Horizontal pipe will work, but the following procedure must be followed: ■ Drill on the top side of the pipe, not the bottom. This will help keep water away from the drill. This also keeps normal sediment from collecting in the valve. 3. Determine the length of copper tubing you need. Measure from the connection on the lower left rear of refrigerator to the water pipe. Add 7 ft (2.1 m) to allow for cleaning. Use ¹⁄₄" (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square. 8